Ella EW-SS-A-STD Guia de Instalação descarregar pdf (Página 25)

www.ellasbubbles.com Page 25 08/14

www.bciacrylic.com

INSTALLATION / WALL SURROUNDS

PLUMBING WALL INSTALLATION CONTINUED

Step 10: Remove the release paper. Apply the silicone in between the butyl tape in a “Z” pattern, keeping the bead about ¼” thick. (Image G)

Step 11: Clean the back of the new panel with denatured alcohol or damp cloth. Press the panel rmly into place. Remove the slip sheeting and wipe down

the panel to ensure it’s secured.

Step 12: Attach the plumbing xtures with Teon® tape.

(Image H)

Step 13: Use silicone to ll in the gaps before the escutcheon plates are afxed. Seal behind and around the xtures. (Image I)

G H I

BACK WALL INSTALLATION

BULLNOSE EDGE FINISHES

There are three options for nishing the ends of your side walls—Option 1: the bullnose edge; Option 2: the use of a tri-guard

under the wall panel; or Option 3: the use of a tri-guard over the wall panel. You should nish the edge as you did when installing the

plumbing wall. See pages 39 and 40 for directions on the three nishing options.

BACK WALL —TEMPLATE MEASURE

Step 1: Using the large wall template, place the template on the back wall, with the long edge against the soap dish wall and the short sides tight against

the ceiling and top of tub or shower base.

(Image J)

Step 2: Check for any gaps due to bowed walls or other miscellaneous reasons, and adjust accordingly. Once you have set the angles, tighten the lock-

knobs and remove the template.

There are two measuring options: the template method and the level method. The following is the template method. Please refer to

page 45 for the back wall level method.

J K L

Tip:

Be extremely careful not to bump the template once you’ve set your angles. If you do, you will need to go back and re-template.

Step 3: Measure from the soap dish wall side out to the location where the bullnose edge or tri-guard will end. In most cases, this location should be at

least

¼” past the end of the existing tile. (Image K)

Step 4: Make sure that back wall bullnose edge matches up to the bullnose edge on the ceiling. (Image L)

Back Wall

Installed Ceiling Panel

INSTALLATION / WALL SURROUNDS

Wall Surrounds

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 47 48

Comentários a estes Manuais

Sem comentários

Ella EW-SS-A-STD Guia de Instalação Página 25

Comentários a estes Manuais